Installation & Assembly

1. You may purchase a fan with Light Pan instead of cluster light kit mentioned
above. For any kind of light kit, you should complete the blade installation before
attaching this light kit assembly. REMEMBER to discount the main power before
installing the light kit by removing the fuse or circuit at the electrical panel box
2. The whole light kit assembly includes the above parts. Locate these parts from
the package and be careful not to damage the glass shade.
3. Locate the two light kit wires from the switch housing of the fan assembly. Attach
the light kit wires from the light pan to the light kit wires of the switch housing,
White to White, Black to Blue of the switch housing using the wire nuts provided.
4. Align the three holes on the light pan with the three holes on the switch housing
rim. Secure the light pan onto the switch housing with the three screws and
washers provided.
5. Install the light bulb ont o the lampholder sockets.
6. The glass shade belongs to the twist-and-lock type. The rim of the glass shade
comes with two grooves. Align the openings of the two groves with the two
notches of the light pan.
7. Turn the glass shade under the light pan along the grooves until the glass is
completely in place. When it is locked in place, it cannot be loosened just by
counter-rotating the glass. Try this to make sure that the glass is safely locked.
8. Route the two pull chains through the two holes on the side if the light pan.
9. Attach the pull chain extensions at this stage by passing the extension chains.
10. Check that all assemblies are firmly secured. Your light kit is now ready for use.
INSTALLING DISC LIGHT KIT
(
OPTIONAL
)
Page 13
WARNING:
All suspended fan (not hugger) with 190W light limiter. If the total wattage of the light bulb(s)
is more than 190W, the light is OFF until the total wattage reduce to below 190W.