Installation & Assembly

1. Remove switch housing screws and then remove bottom cap of switch housing
shell on fan.
2. Locate two wires in the switch housing (white and blue labeled “for light”).
Connect them to the light kit wire connectors (Fig. 12-2).
White to white
Blue to blue
3. Carefully push all wires back into the switch housing. Then attach housing cover
plate to switch housing with the 3 screws provided.
4. Attach the glass shades to the light kit, using 3 thumb screws per shade
(provided). Do not over-tighten the thumb screws as glass may break. Install
light bulbs.
5. Slide the bowl glass over the threaded nipple, followed by the cap, and then finial.
Twist finial clockwise until snug (see figure 12-2).
6. Lower chains thru hole in bowl and glass cap.
7. Attach chain extension (see figure 12-3).
8. Restore power and your light
9. If the light kit does not work, turn off the electricity and lower the canopy on your
ceiling fan. Make sure the blue wire is connected to black household wires
(please refer to electrical connections section in this manual).
Page 14
INSTALLING BOWL LIGHT KIT (OPTIONAL)
Secure those wires with wire nuts in the fan.
kit is ready for operation.
WARNING:
All suspended fan (not hugger) with 190W light limiter. If the total wattage of the light bulb(s)
is more than 190W, the light is OFF until the total wattage reduce to below 190W.
Swtich Housing
Scoket
Light kit Fixture
Figure 12.1
Blue
Black
Switch Housing
White
Socket
Thread Nipple
60w Medium Base
Light Kit Fixture
Figure 12.2
Figure 12.3
Chain Extension
Bowl Glass
Cap
Firial