Installation & Assembly

3. Tighten motor set screw. Check the strength of this connection (pre-tightened at
factory) by holding the motor housing in position and turning the downrod counter
clockwise. If this connection slips, retighten motor setscrew and locknut. Follow the
same procedures as mentioned above for downrod setscrew.
4. Install ball into hanger bracket opening. The tab opposite of the hanger bracket
opening should fit in slot on ball (Fig 8) . For the mounting plate version fan, hang the
5. Make wire connections (refer to section titled “Electrical Connections”) “For
compliance with local codes and regulation. If installing the secondary support
safety cable in the U.S., do not secure the safety cable within the outlet box!” You
should mount the secondary support screw and cable outside the outlet box.
6. Slide canopy up, and fasten to hanger bracket with the 4 screws provided.
WARNING: To avoid damaging the blade arms and blades, do not install either until
fan is fastened to ceiling. To avoid motor shift, handle fan by downrod or switch
housing only.
Page 7
holde of upper canopy to the J hook on the mounting plate.