Installation Guide

Troubleshooting.
Warranty.
Parts Replacement.
WARNING: Failure to disconnect power supply
prior to troubleshooting any wiring issues may
result in serious injury.
For parts and information, please refer to
"Parts Inventory" on page 2.
page 10
Problem: Fan fails to operate.
Solutions:
1. Check wall switch to fan.
2. Verify that reverse switch is set completely in
either direction.
3. Check to be sure fan is wired properly.
4. Verify that male plug and female plugs are
connected properly in light kit fitter.
Problem: Light kit not lighting.
Solutions:
1. Check wall switch to fan.
2. Check that bulb is installed correctly.
3. Check to be sure wires in canopy are wired
properly.
4. Verify that male plug and female plugs are
connected properly in light kit fitter.
5. Check to be sure that bulb totals no more than
190W.
[Note: Lamping the light kit with bulb that totals
more than 190W will cause the wattage limiting device to
interrupt the flow of electricity to the light kit.
Problem: Fan operates but lights fail.
Solutions:
1. Check that bulb is installed correctly.
2. Check to be sure wires in canopy are wired
properly.
3. Replace defective bulb with same type of bulb.
4. Verify that male plug and female plugs are
connected properly in light kit fitter.
5. Check to be sure that bulb totals no more than
190W.
[Note: Lamping the light kit with bulb that totals
more than 190W will cause the wattage limiting device to
interrupt the flow of electricity to the light kit.
Problem: Fan wobbles.
Solutions:
1. Use the balancing kit in one of the hardware
packs. If no blade balancing kit is provided, please
call Customer Support
2. Check to be sure set screw(s) on motor
housing yoke is (are) tightened securely.
3. Check to be sure set screw on hanging ball is
tightened securely.
1-YEAR WARRANTY:
or repair any fan which has faulty performance due to a
defect in material or workmanship.
LIFETIME WARRANTY: