Assembly Instruction

1 2
To screw Steel with thread
on both ends (F) to Sheet
iron (A).
To inset Glass top (B)
and Electronic box (C)
To inset Metal tube (D) to
the finished portion as the
1st stage, then mount Metal
plate(E).
1 st Stage.
To put Nut (H) then tighten
* * Washer (G) with Wrench(l).
Cleaning & Care
Treat surface with care. Surface is resistant to scratches but is not scratch resistant.
Clean surfaces with a dry or damp soft cloth.
Do not use abrasive cleaners. Hardware may loosen overtime.
Periodically check that all connections are tight.
2