Installation & Assembly

ManualsBrandsZipcode Design ManualsBathroom Vanity LightingKneeland 1-Light Bath Sconce

ASSEMBLING & INSTALLATION INSTRUCTIONS

The drawing shown may not exactly match the product enclosed.

However, the installation instructions do apply to this product.

 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.

 ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.

ASSEMBLING THE FIXTURE (Fig.1)

1. Shut off the power at the circuit breaker box. Remove old fixture

and all hardware from Junction Box. Carefully unpack your new

fixture and lay out all the parts on a clear area. Take care not to lose

any small parts necessary for installation.

2. Attach the mounting plate to the junction box using two junction box

screws as shown. The side of the mounting plate marked “GND”

must face out. The junction box is not included.

3. Guide fixture wires through hole in center of mounting plate.

4. Follow wiring instructions carefully.(see fig.2)

5. Attach the back plate of the lamp body (B) onto the junction box,

aligning the back plate holes with screw hole of the mounting plate

in side, then lock it securely with mounting screws.

6. Install the light bulb(not included) in accordance with the fixture’s

specifications. NOTE: DO NOT EXCEED THE MAXIMUN

WATTAGE RATING!

7. Raise the glass(A) insert the cover of lamp holder, by turning it

clockwise until tight.

CONNECTING THE WIRES (Fig.2)

1. Connect the electrical wires as follows. Connect the Black wire from

the fixture to the black house (hot) Wire. Connect the white wire from

the fixture to the white (neutral) house wire. Make sure all wire nuts

are secured. You may wrap the connections with electrical tape. If

your outlet box has a ground wires (green or bare copper) connect

fixture’s ground wire to it. Otherwise attach the bare copper fixture

wire to the green ground screw on the mounting plate.

2. Tuck the wire connections neatly into the wall junction box.

Your installation is now complete. Return power to the junction

box and test the fixture.

Fig.1

Mounting plate

Junction Box

Supply Ground Wire

Supply wire

Box screw

Fixture Ground Wire

Mounting screw

(Not included)

FIXTURE

WIRES

Black or

Smooth

HOUSE

WIRES

Black(Hot)

FIXTURE

WIRES

White or

Ribbed

FIXTURE

WIRES

Bare

Copper

(Ground)

HOUSE

WIRES

White

(Neutral)

HOUSE

WIRES

Green or Bare

Copper(Ground)

FIG.2

Summary of content (1 pages)

PAGE 1
ASSEMBLING & INSTALLATION INSTRUCTIONS The drawing shown may not exactly match the product enclosed. However, the installation instructions do apply to this product.   Fig.1 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER. ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR. ASSEMBLING THE FIXTURE (Fig.1) 1. Shut off the power at the circuit breaker box. Remove old fixture and all hardware from Junction Box. Carefully unpack your new fixture and lay out all the parts on a clear area.