Installation & Assembly

STEP 1:
STEP 2:
Hardware & Tool required
Ax12 Bx12 Cx12 Dx1
1
2
C
B
D
Please put the Chair/Sofa Body (1) upside down on a carpeted or padded area by two adults.
Open the Zipper on the bottom of Chair/Sofa Body (1) as shown, to make the corners fully visible .
Take out 4 pieces of Leg (2&3) and Hardware Package from the inside of Chair/Sofa Body(1).
1
4pcs Leg
Zipper on the bottom of chair/sofa body
+
Hardware Package
Position one of Front Legs (2) at the corresponding corner as shown.
Insert 3 pieces of Bolt (A) with 3 pieces of Spring Washer (B), Flat Washer (C) into the pre-drilled holes on the bottom
Chair/Sofa Body (1) through the pre-drill holes on Front Leg (2) as shown.
Repeat the same steps for the remaining Front Leg (2) and Back Legs (3).
Use Allen Wrench (D) to tighten all the Bolts (A) clockwise until secure.
Close the zipper on bottom of Chair/Sofa Body (1).
A
B
C
A
A
C
2
3 3
A
B
C
A
B
C
A
B
C
A
B
C
A
B
C
A
B
C
A
B
C
A
B
C
A
B
B
C
CHAIR/SOFA
Page 2 of 3