ZP19011 ASSEMBLY INSTRUCTIONS ZIPPITY GALVANIZED STEEL AND VINYL SURFACE MOUNT 2-PACK (30” H X 3 1/4” W) ASSEMBLY INSTRUCTIONS ZP19011 60 MIN Approximate assembly time Want to see a video on how to assemble this product? Scan the QR code WWW.ZIPPITY-OUTDOOR.COM WWW.ZIPPITY-OUTDOOR.COM 1 VER.
ZP19011 ASSEMBLY INSTRUCTIONS GENERAL INFORMATION IMPORTANT k Check the inside of the larger pieces in your box for other materials packed inside. k When assembling components, place on a non-abrasive surface (i.e. shipping box) to avoid scratching. k We recommend an area approximately 5’x 8’ for unobstructed assembling. k You should not need to use excessive force when assembling components.
ZP19011 ASSEMBLY INSTRUCTIONS 3 1/4 in 30 1/4 in 3 1/2 in Ø3/8 in 4 in WWW.ZIPPITY-OUTDOOR.
ZP19011 ASSEMBLY INSTRUCTIONS STEP 1: LAY OUT MATERIALS A Surface Mount (2) NOT INCLUDED WITH PURCHASE: ¼” Hex Bolts(8) ¼” Washer (8) ¼” x 4” Hex Head Bolt w/ Nut and Washer (8) Only needed if installed on wood 4 ¼” x 3” Concrete Wedge Anchor (8) Only needed if installed on concrete 2” x 6” Wood Support (1) Only needed if installed on wood WWW.ZIPPITY-OUTDOOR.
ZP19011 ASSEMBLY INSTRUCTIONS STEP 2A: MOUNT TO CONCRETE STEP 2A.1 STEP 2A.2 Locate the position of your Surface Mount (A) and mark the four anchor holes. Drill (4) ¼” diameter holes 3” deep through the concrete. You will need a hammer drill and a masonry drill bit. Install (4) ¼” x 3” concrete wedge anchors. A STEP 2A.3 STEP 2A.4 Place the surface mount over the four anchor bolts and check that they are level.
ZP19011 ASSEMBLY INSTRUCTIONS STEP 2B: MOUNT TO WOODEN DECK STEP 2B.1 Locate the position of your surface mount and mark the four bolt holes. STEP 2B.3 Drill (4) ¼” diameter holes through the deck and support. STEP 2B.2 Measure the distance between your joists and fasten a 2” x 6” wood support directly below where the surface mount will be installed. This will give the surface mount additional structural strength. STEP 2B.4 Place the surface mount over the holes and check if it is level.
ASSEMBLY INSTRUCTIONS ZP19011 STEP 2B.5 Once level, fasten the surface mount using (4) ¼” x 4” hex head bolts with nuts and washers. WWW.ZIPPITY-OUTDOOR.
ZP19011 ASSEMBLY INSTRUCTIONS 6935 Reames Rd. Ste. K. Charlotte, NC 28216 support@zippity-outdoor.com 704-892-5222 877-234-6196 WWW.ZIPPITY-OUTDOOR.COM 8 WWW.ZIPPITY-OUTDOOR.