Owner's Manual

Figure 10: Calibrating to Level
Calibrating to Plumb
• Place the LaserVision against a stable, nearly vertical surface (See note (1) above).
• Press and hold the ON/OFF button for about three seconds until the bars start
moving up and down (Figure 9, page 7) and an audio tone sounds. The axis
arrow and the number 1 will blink while the LaserVision is calibrating the first
position.
• When the indicators stop moving and the second audio tone sounds, the number 2
will appear. Rotate the LaserVision 180 degrees while keeping the same end up
(Figure 11 below).
8
1a
A
B
A
B
1b
off
on
3 sec
off
on
A
B
2b
A
2a
B
off
on
3 sec
off
on
Figure 11: Calibration to Plumb