Owner's Manual

Operation
Hand receiver mode
Hand receiver mode gives you
optimum reception quality with a
constantly high speed of rotation
(maximum speed = 550 rpm).
Activate this mode by pressing the Hand
Receiver button on the RCR control
panel.
Pressing the same button on the Remote
Commander control panel activates the
Remote Commander as a laser receiver.
Note referring to all modes
The red LED lights up when you've
reached the limit of range (e.g.
maximum speed, biggest scan angle).
Using the Remote Commander as a Laser Receiver
Sound volume control
Use the + and - buttons to adjust volume
after pressing the receiver activation
button. The LEDs light up to indicate
low, medium, and maximum sound,
or sound off.
Working with the laser receiver
The receiver can detect the laser beam at distances of up to 400 feet.
Hold the laser receiver with the IR receiver at the height
of the rotating laser beam and facing the laser beam.
By means of LEDs and sound signals you can find the
exact height of the laser level beam.
If the top LED lights, a descending series of tones sounds.
Move the Remote Commander downwards.
If the bottom LED lights, and an ascending series
of tones sounds, move the Remote Commander
upwards.
When the middle LED is yellow, you are very close,
and the two-note tone tells you to move the
Remote Commander slowly upwards or downwards,
until the middle LED turns green.
When the middle LED is green, a series of equal tones sounds.
The Remote Commander is exactly at laser level.
Note:
When the middle LED gives off yellow light, you are already
within a 3/16" range round the laser level (free-hand
measuring). You will achieve a more accurate result (fine measuring), when
the RemoteCommander is fixed (e.g. attached to a levelling staff). Then the
green LED shows the exact center.
Using the Remote Commander as a Laser Receiver
Activating the laser receiver
mode
Switch on the laser receiver mode.
In order to ensure that the mode is also
activated on the RCR, point the IR
transmitting diode of the
RemoteCommander at the RCR unit.
Activation is indicated by lighting of
red/green LEDs and a signal sound on
the Remote Commander.