User's Manual
Table Of Contents
- Safety Measures
- 1 Instruction for Use
- 2 Main Menu
- 3 User Management
- 4 User Role
- 5 Communication Settings
- 6 System Settings
- 7 Personalize Settings
- 8 Data Management
- 9 Department Management
- 10 Shift Set
- 11 Report
- 12 Access Control
- 13 USB Manager
- 14 Attendance Search
- 15 Autotest
- 16 System Information
- 17 Connect to ZKBioAccess IVS Software
- Appendix
MB10-VL User Manual
Page | 41 Copyright©2021 ZKTECO CO., LTD. All rights reserved.
Factory Reset
Restore the device settings to their factory state, such as communication settings, system settings, etc.
(Do not clear registered user data).
Select the Reset option on the System interface. Select OK to reset.
USB Upgrade
Insert the U disk with upgrade file into the device’s USB port, and in the initial interface, press [M/OK] >
System > USB Upgrade to complete firmware upgrade operation.
Select USB Upgrade option on the System interface.
Note: If an upgrade file is needed, please contact our technical support. Deny firmware upgrade under
normal circumstances.