User's Manual

G3 Pro User Manual 45
Retry Times To Alarm
When the number of failed verification reaches the set value (value ranges from 1 to 9
times), the alarm will be triggered. If the set value is None, the alarm will not be triggered
after failed verification.
NC Time Period
To set time period for Normally Closed mode, so that no one can gain access during this
period.
NO Time Period
To set time period for Normally Open, so that the door is always unlocked during this
period.
Valid holidays
To set if NC Time Period or NO Time Period settings are valid in set holiday time period.
Choose [ON] to enable the set NC or NO time period in holiday.
Speaker Alarm
When the [Speaker Alarm] is enabled, the speaker will raise an alarm when the device is
being dismantled.
Reset Access Setting
To restore access control parameters.
Note: After setting NC Time Period, please lock the door well, otherwise alarm might be triggered during NC Time Period.
10.2 Time Schedule Settings
Time Schedule is the minimum time unit of access control settings; at most 50 Time Schedules can be set for the
system. Each Time Schedule consists of 7 time sections (a week), and each time section is the valid time within 24 hrs.
Tap Time Schedule on the Access Control interface.
Valid Time Schedule: 00:00 ~ 23:59 (Whole-day valid) or when the end time is greater than the start time.
1. Invalid Time Schedule: When the end time is smaller than the start time.
2. The default time zone 1 indicates that system is open all day long.
3. Tap the date on which time zone setting is
required.
1. Tap the input box of search time zone.
2. Enter the number of time zone (50 in total
to be searched.)
4. Press Up and Down to set the start and end
time, and then press Confirm (OK).