User's Manual
Table Of Contents
- 1 Guidance Notes
- 2 Main Menu
- 3 Adding a User
- 4 User Management
- 5 User Role
- 6 Comm. Settings
- 7 System Settings
- 8 Personalize Settings
- 9 Data Mgt.
- 10 Access Control
- 11 USB Manager
- 12 Attendance Search
- 13 Print Settings ★
- 14 Short Messages
- 15 Work Code
- 16 Autotest
- 17 System Information
- Appendix 1 Printing Function ★
- Appendix 2 Statement on the Right to Privacy
- Appendix 3 Eco-friendly Operation
60 G3 Pro User Manual
Appendix 1 Printing Function ★
Remarks: Only some models support printing function.
Function Instruction
This function only supports serial port but not parallel port printing. Printing content is output via RS232 format;
verification information will be output every time to the serial port. Printing is available if a printer is connected, or a
hyper terminal can be used to read output content.
Connection between the device
and printer
Device Printer
2TXD <-----> 3 RXD
3RXD <-----> 2 TXD
5GND <-----> 7 FG
RS232 Pin-line order
[Connection Diagram]
[Operation]
1. In the initial interface, press [M/OK] > Comm. > Serial Comm > Baudrate, and choose 19200 as the baud rate.
2. In the initial interface, press [M/OK] > Print. To set the printing format and parameters, please refer to
13 Print
Settings ★
Note:
1. The baud rate of the device and printer (hyper terminal) should be consistent.
2. If the default printing format is not satisfactory, you may contact our company to customize other
formats.