User's Manual
Table Of Contents
- Safety Measures
- 2 Overview
- 3 Instruction for Use
- Main Menu
- 5 User Management
- 6 User Role
- 7 Communication Settings
- 8 System Settings
- 9 Personalize Settings
- 10 Data Management
- 11 Access Control
- 12 Attendance Search
- 13 Print Settings
- 14 Autotest
- 15 System Information
- 16 Connect to ZKBioAccess IVS Software
- Appendix 1
- Appendix 2
RevFace15[TI] User Manual
Page | 15 Copyright©2021 ZKTECO CO., LTD. All rights reserved.
Verification Mode 3.5
3.5.1 Facial Verification
1:N Facial Verification
1. Conventional verification
In this verification mode, the device compares the collected facial images with all face data registered
in the device. The following is the pop-up prompt of a successful comparison result.
2. Enable temperature screening with infrared
When the user enables the Enable temperature screening with infrared function, during user
verification, in addition to the conventional verification method, the user's face must be aligned with
the temperature measurement area to measure the body temperature before the verification can be
conducted. The following are the popups of the comparison result prompt interface.
NOTE: This function is only applicable to products with temperature measurement module.