QR50 QR Code Access Control Reader User Manual Version:V1.0 Date:2021.04.
Important statement Copyright Notice Thank you for choosing this product. Before use, please read this installation guide and instruction manual (hereinafter referred to as the instruction manual) carefully to ensure that the product is used correctly, has a good use effect and verification speed, and avoids unnecessary damage to the product. Without the written consent of the company, no one may copy or disseminate any content of this manual in any form.
Revision Record Version Revision Content Revision Date V1.
Contents IMPORTANT STATEMENT ......................................................................................................................... 1 REVISION RECORD ..................................................................................................................................... 2 CONTENTS ..................................................................................................................................................... 3 1、INSTALL EQUIPMENT ..........................
1、Install Equipment Installation notes: In order to ensure the normal use of the equipment, users are requested to strictly follow the installation instructions 1 2 60mm or 66mm Buy the standard type 86 dark (bottom) bo x from the market, and the installation hole Face shell (with panel) distance is 60mm or 66mm. The installer di Remove the cover (with panel) from gs a hole on the wall surface according to t the device.
2、Product Introductions The QR code access control card reader is a new generation of smart access control card reader developed by our company. The product has high-end appearance, fast scanning speed, high recognition rate, strong compatibility, and can be connected to any access control controller that supports Wiegand input.
1.Wiegand or RS485 Communication ①First, connect the QR code reader to the controller via Wiegand or RS485, and then connect the +12V power supply. The QR code reader does not need to be connected to the lock body when it is used as a reader. The controller in the figure only lists part of the wiring. In addition, there are many ways to connect between the machines.
②Then, open the "HID keyboard" in the DEMO software settings, and then put the card or QR code (paper, electronic, mobile phone) into the recognition range of the card reader, the card reader will automatically obtain the information carried by the card or QR code And transmit to the PC terminal, can demonstrate through the text document. 4、Operation and Setting of Card Reader Introduce how to configure the card reader through Demo software. 4.1 One-key Configuration Operation steps 1.
2. Successfully connected, click download in the download configuration area below。 3.
-----The End 4.2 Basic Operation of Card Reader Operation Steps 1.
2. Enter the main page of advanced settings。 3.
b) The user can set the parameter information of the card reader by himself, and then click "write configuration" to configure the parameter information of the QR code reader。 Params Description RS485 address 0: Broadcast address, that is, no matter the machine's 485 address is set to 0~255, it can be connected by communication.
not transfer the card number/QR code data to the computer。 Baud rate If you choose a serial port connection, you can set the baud rate。 Write configuration When the above parameters are modified, click "write configuration" to make the new configuration effective。 Read configuration Get the current configuration of the card reader and display it。 Support resetting the card reader to factory settings。 -----The End 4.
display it。 -----The End 4.
4.
15
FCC Warning: This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any inte rference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.