User's Manual
4
1、Install Equipment
Installation notes: In order to ensure the normal use of the equipment, users are requested to strictly follow the
installation instructions
Buy the standard type 86 dark (bottom) bo
x from the market, and the installation hole
distance is 60mm or 66mm. The installer di
gs a hole on the wall surface according to t
he length, width and depth of the standard
86-type dark (bottom) box to place the dar
k (bottom) box and fix it with cement sand
60mm or
66mm
Remove the cover (with panel) from
the device. It is necessary to gently
remove the panel from the USB port
side to avoid damage to the LED light
when removing it
Face shell (with panel)
When installing, connect the wire and
debug it, then put the device into the
86-type concealed (bottom) box as shown
in the figure, and fix the device with two
M4*15PB mechanical screws. Pay attention
to the downwards on the device with the
boss.
The device has this boss facing
downwards during installation
First find the right alignment point, and then
buckle the shell (with panel) into the device
(as shown in the figure), pay attention to the
assembly direction during installation and
check whether the printing on the rear panel
is upright.
The panel is printed upright, and the notch under the
shell is aligned with the boss under the device
1
2
3
4