User's Manual

Countertop TA Terminal User Manual 15
6.3 Set Setting Reports
Select Upload Att. Setting Report then
press OK.
Uploading table……
Data upload succeed!
Press
M/OK to take out the
USB disk or SD card.
The employee information, shifts, and departments in the setting reports can be viewed after you select User, Dept set,
and Shift set respectively on the initial interface.
Then you can view the information of employees, shifts, and departments either on relevant interfaces or in downloaded
standard reports.
Note: If the schedule time format is incorrect, an interface shown in the following figure will be displayed:
Press M/OK.
Re-upload the attendance setting report after modification.
For the correct schedule time format,
see "What is the correct time format used in the
setting reports" in the "
Self-Service Attendance
Terminal FAQs
."