User's Manual
Table Of Contents
16 Countertop TA Terminal User Manual
7 System Setting
7.1 System Setting
Set system parameters to meet user requirements to the greatest extent in terms of functions and display.
Press M/OK on the initial interface.
Select System and press M/OK.
Select System and press M/OK.
Set system parameters.
Threshold (1:1): This option is used to set the extent of matching between an input ID/fingerprint and that stored in
templates in the ID and fingerprint identification mode.
Threshold (1: N): This option is used to set the extent of matching between an input ID/fingerprint and all those stored
in templates.
The recommended thresholds are as follows:
FRR FAR
Match threshold
1:N 1:1
High Low 45 25
Medium Medium 35 15
Low High 25 10
Date Format: This option is used to set the time format displayed on the initial interface of the device.
Select a desired date format by pressing . The device supports 10 date formats: YY-MM-DD, YY/MM/DD, YY.MM.DD,
MM-DD-YY, MM/DD/YY, MM.DD.YY, DD-MM-YY, DD/MM/YY, DD.MM.YY and YYYYMMDD.
Key Voice: Set whether to generate a beep sound in response to every keystroke by pressing . Select Y to enable the
beep sound, and select N to mute.
Voice prompts: Set whether to generate a voice prompt in response to every operation by pressing .
Retry Period: If a user’s attendance record already exists and the user signs in again within the specified period (unit:
minute), his/her second attendance record will not be stored. (Value scope: 0–60. 0: Save all the records passing the
verification.)
Log Alert: When the available space is insufficient to store the specified number of attendance records, the device will
automatically display a warning message. (Value scope: 1─99. 0: No warning message is displayed when the free space
is zero.)
Lan: You can select a language for the device based on your requirements.
Sensitivity: Set the fingerprint collection sensitivity. It is recommended to use the default value Medium. When dryness
results in slow reactions of the fingerprint collector, you may set this option to High to enhance the fingerprint collector's
sensitivity. When high humidity results in illegible fingerprint images, you may set this option to Low.
Move the cursor to the desired option by pressing
▲/▼
. Enter a desired
value in the entry box by using the keypad. Press
in the scroll box to
switch to the desired value. After finishing the setting, press
M/OK to
save your settings and return to the previous interface. Press
ESC to
cancel your settings and return to the previous interface.