User's Manual
Table Of Contents
18 Countertop TA Terminal User Manual
Press ▲/▼ to switch among the entry boxes. Enter the switch time using the numeric keypad and the switch name
using the T9 input method. Press ◄/► to choose a state. After the setting is complete, press M/OK to save and go back
to the previous interface. Press ESC to cancel the setting and go back to the previous interface.
7.4 Bell Settings
Lots of companies need to ring their bells to signal the start and end of work shifts, and they usually manually ring their
bells or use electric bells. To lower costs and facilitate management, we integrate the time bell function into the FRT. You
can set the alarm time and duration for ringing the bell based on your requirements, so that the attendance machine will
automatically play the selected ring tone, and stop playing the ring tone after the set duration.
Press M/OK on the initial interface.
Select System and press M/OK.
Select Bell and press M/OK.
Press▲/▼to select a bell then
press M/OK.
Press▲/▼and M/OK to select
items. When the setting is
completed, press OK to save the
setting and exit.
When editing successful, an
interface shown above.
Time: Set a time point of one day or several days from Sunday to Saturday when the attendance machine automatically
plays a bell ring tone.
Times: Set the alarm times.
State: Set whether to enable the bell.
7.5 Update firmware
You can upgrade the firmware program of the FFR terminal by using the upgrade file in the USB disk through this
parameter.
Press
M/OK
on the initial interface. Select
System
and press
M/OK
. Select
Update firmware
and
press M/OK.
If you need such upgrade file, please contact technician. Usually, firmware upgrade is not recommended.