User's Manual
Table Of Contents
4 Countertop TA Terminal User Manual
3. User Management
3.1. Add a User
Through this submenu, you can browse the user information stored on the terminal, including the user ID, name,
fingerprint, password, department, and user role.
Press M/OK on the initial interface.
Select User and press OK.
Select Add user and press OK.
3.1.1 Enter a User ID and Name
The terminal automatically allocates an ID starting from 1 for every user in sequence. If you use the ID allocated by the
terminal, you may skip this section.
Select User ID.
Enter the user ID using keypad,
then press OK.
Press ▼ to select Name.
Press M/OK to open input
method.
Press▲/▼to switch input
method and enter the Name.
3.1.2 Enroll a Fingerprint
Press ▼ select Enroll FP and press
M/OK.
Place your finger on the
fingerprint sensor properly. For
details, see
1.2 Finger Placement.
Place the same finger on the
fingerprint collector for three
consecutive times correctly until
enrollment succeeds.
Note: If the enrollment fails, the system will display a prompt message and return to the [Enroll Fingerprint]
interface. In this case, you need to repeat the operations of step 2.
For details of operations on
keyboard interface, see
T9 input.
The terminal supports the
23
-character names by default.