Used to connect unto & auxiliary output devices. Used to connect unto 8 salary Input devices. DCIZ3A ‘Sets the RS4BS/OSDP dress of the EX0B08 and set the RS485/0SDP communication etc. Introduces the use of DIP switches. indicates the running states. Used for RS485 communication. Used to connect another EX0808 expansion board, Indicates the communication states of the RS485.
RUN Indicator (Green) Flushing Green LED Continuously indicates that the device is running normal. COMM Indicator (Yellow) Flashing Yellow LED Continuously Indicates that the device Is online and communicating. Solid Yellow LED Indicates that the device Is cf fine (after 10 seconds of communication allure) and communication galled. D0 & Solid Yellow LED when the device Is powered an. Rs425 Terminal Resistance Notes: ‘There are six DIP switches on the EX0808 expansion board and their functions are: 1.
Use the software after connecting the EX0808 module to the controller. The EX0808 module can be connected to the inbox Pro Series. The connection with inbound Pro is shown as an example: below: inbound Pro Default P address: 1921601.201 Ursuline Mack 255.255.3550 pe 83 Router address: 1921681130 Sumac mask 255252550 Notes: 1. A maximum of eight EX0808 extended boards can be connected to an inbound Pro controller. 2.
After wiring, please follow the below steps: 1} Add Inkblot Pre controller on the software. 2. Logan to ZKBlaSecurityV5000 software and click on Access > Device > Device > Search, 10 search the device on the software. The searched devices are displayed automatically. b. First, change the IP address of the device by dickering Modify IP Address. Then a new window will pop-up, enter the relevant information and dick OK.
3} On the software, dick Access > Device > Auxiliary Input / Auxiliary Output to view all the auxiliary Inputs/outputs, 1} Remote operation 2. Ont he software, dick Access > Device > Auxiliary Output stonewall the laudatory output. b. Selectivity output and click Re mate Open,a new window will pop-up. © Enter the relevant Information and dick Start. You will be able to remotely open the device ‘connected to theauxllaryoutputviasoftware.
2} Nonfunctional On the software, click Access > Access Control > Linkage > New and fil in all the relevant information tosetanewlinkage operation. The operation is as follows: a. First electronically device on the stand click Device to choose. b. Click Add to add the linkage rigger condition from drop-down and selectness point on the list. ¢. Stouthearted point of the Door and the Auxiliary Output. d.
