Quick Installation Guide

InstructionsforInstallationandUseoftheC3100/200/400ControlPanel
6
Outputload:workingvoltageAC≤30V,ratedcurrent≤8A;DC≤36V,rated
current≤5A.
Ctype electronic lock relay output terminal: 10A contact current, 12V DC,
withLEDstatusindications.
Outputterminaloftheauxiliaryrelay:2Acontactcurrent,30VDC,withLED
statusindications.
Withdetachableconnectionterminalsmadeofalloysteelnonmagneticflange
materials.
OutlinedimensionsofthecontrolPCB:160mm(length)×106mm(width)for
C3100/200;218mm(length)×106mm(width)forC3400.
MountingholedimensionsofthecontrolPCB:147.32mm(length)×91.44mm
(width)forC3100/200;203.2mm(length)×106mm(width)forC3400.
External boxdimensions:345mm×275mm×70mm.
2.3ControlOperatorPanelIndicators
WhentheC3100/200/400ispoweredon,normallythePOWERindicator(red)islit
constantly,theRUNindicator(green)flashes(indicatingthesystemisnormal),and
otherindicatorsarealloff.
Exceptthecasesasfollows:
1. LINK indicator (green): indicates proper TCP/IP connection if it is lit
constantly;
2. ACTindicator(yellow):indicatestransmissionofTCP/IPdataifitflashes;
3. TXindicator(yellow):indicatessendingof485dataifitflashes;
4. RXindicator(green):indicatesreceivingof485dataifitflashes;
5. Lock indicator (green): indicates unlocking if it is lit constantly (if the
auxiliary outputindicator is lit in green constantly, it indicatesthe auxiliary
deviceisenabled);
6. CARDindicator(yellow):indicatesinputofWiegandsignalifitislit.