FAQ

29
Under Cabinet Installation
PREPARATION
• Decide the location of the venting pipe from the hood to the outside.
• Check hood for clearance.
• A straight, short vent run will allow the hood to perform more efficiently.
• Try to avoid as many transitions, elbows, and long runs as possible. This may
reduce the performance of the hood.
• For installing under the cabinet with recessed bottom, attach 4-inch wide wood
filler strips (not provided) on each side.
• Puncture the knockout holes (for mounting under the cabinet) on the hood.
1. Measure distance between stove top and the bottom of the range hood. A
distance of 30” to 36” is recommended.
2. Attach mounting brackets to the back of the hood.
3. Mark the leveling point of the hood. Position two mounting screws on the wall,
leaving ¹/₈” space away from the wall. Make sure that you are mounting the
hood to a secure backing to hold the weight of the hood.
4. Tighten ducting (provided) with the hose clamp provided. Use silver or duct tape
wherever needed.
5. Draw electrical wires through cabinet access opening, center the hood beneath
the cabinet.
6. Align hood-mounting brackets to the screws on the wall and hook hood into
place. Tighten screws to secure hood to the wall.
7. Connect ducting.
UNDER CABINET INSTALLATION
Screw
Screw
Screw