Under Cabinet Installation Installation Tutorial Video 19
Under Cabinet Installation Preparation ► ► ► ► Decide the location of the venting pipe from the hood to the outside. Check hood for clearance. A straight, short vent run will allow the hood to perform more efficiently. Try to avoid as many transitions, elbows, and long runs as possible. This may reduce the performance of the hood. ► For installing under the cabinet with recessed bottom, attach 4-inch wide wood filler strips (not provided) on each side.
Under Cabinet Installation 5 Draw electrical wires through cabinet access opening, center the hood beneath the cabinet. 6 Align hood-mounting brackets to the screws on the wall and hook hood into place. Tighten screws to secure hood to the wall. 7 Connect ducting.
Undercabinet Recirculating Kit Step 1: Open package, locate all neccessary hardware. Included should be 4 screws with 4 washers. Step 2: Line up the recirculating kit with the top of the range hood. 11 7 8“ 29 ¾“ - 35 ¾“ 4 ¾” Step 3: Secure the recirculating kit with the provided screws. Once secure, begin tightening each screw until the recirculating kit is flush with the range hood. Step 4: Install undercab per range hood installation guide. No time to read? Scan for a quick video.
