Installation Guide

25
Problem
There is leakage under the
handle.
Water will not shut off
completely.
There is a leak between the
spray head and the hose.
The locking nut has
come loose.
Cartridge may be
defective.
The spray head may be
loose or the washer is
not seated correctly in
the hose connection.
Unscrew the lever on the
handle by hand. Loosen set
screw with a hex wrench.
Remove the handle and
unscrew trim cap by hand.
Tighten locking nut with an
adjustable wrench.
Unscrew the level on the
handle by hand. Loosen set
screw with a hex wrench.
Remove the handle and
unscrew trim cap by hand.
Unscrew the locking nut with
an adjustable wrench. Remove
ceramic disc cartridge. Check
for cracks.
Tighten the spray head by
hand until snug. Make sure the
washer is seated correctly.
Possible Cause
Solution
TROUBLESHOOTING