Specification

16 17
Island Hood Installation
Step 1
Locate the center above the stove where the hood is to be
installed. Ensure that the bracket will be secured to solid
wood backing. Attach mounting bracket to the ceiling.
For Designer Island Hood with Crown, refer to
Figure CRN
Step 2
Attach the transition piece and ducting to top of the
hood. Figure 1 and 2
Step 3
Attach the four long angle iron pieces to the hood’s
motor housing. Figure 3
Step 4
Determine desired
height and attach the
four short angle iron
pieces to the long angle
iron pieces that are
attached to the hood.
Figure 3
Step 5
Install the duct work in
the center of the ceiling
bracket.
Figure 1
Figure 3
Island Hood Installation
Figure 5
Figure 4
Step 6
Slide chimney pieces over the angle iron on the
hood. Pull the electrical plug to the top of the chimney
sections. Figure 4
Step 7
Lift the hood to attach the angle iron to the ceiling
bracket. Use screws provided to attach.
Step 8
Make your electrical and ducting connections.
Use rigit duct wherever possible. Try and minimize
the use of elbows. More elbows and longer runs
create higher static pressure. The hood comes with a
grounded three prong plug that can either be direcly
wired or plugged into a 20 amp circuit.
Step 9
Slide top chimney piece up over the mounting bracket
on the ceiling and secure it in place with the provided
screws. Figure 5
For Designer Island Hood with Crown, refer to
Figure CRN2
Step 10
Install stainless steel baffle filters. Before installing
baffle filters, make sure that you insert the grease cup
under the motor blower.
Figure 2
For Designer Island Hood with Crown
Attach the four dowel pins into the
side of one half of the crown. Slide
the crown with the pins onto the
crown bracket. Attach the other half
of the crown by connecting the plugs
into the holes.
For Designer Island Hood with Crown
Figure CRN
Install the appropriate crown bracket
first. Ensure that the bracket will be
secured to solid wood backing. Then
proceed to step 2 through 10.
Figure CRN2