FAQ

8
Installing the Anti-Tip Stability Device
The chains shipped with the range must be properly secured to the rear wall as shown
in the picture on the following page. The height of the bracket from the floor must be
determined after the range legs have been adjusted to the desired height and after
the range has been leveled. If the chain length is too short to properly secure the
range to the rear wall, ask the installer to lengthen it.
Installing the Anti-tip Stability device
A child or adult can tip the range and be killed; Re-engage the
anti-tip device if the range is moved. Failure to do so can result in
death or serious injury.
WARNING
Range Top/Drop-in Installation
Attaching the hotplate
To prevent liquids from accidentally leaking into
the underlying storage space, the appliance is
equipped with a special gasket. To apply this
gasket, carefully follow the instructions in Fig.
3. Lay out the protective sealing strips along
the edges of the opening in the bench top and
carefully overlap the strip end. (See Fig. 3).
insert the hotplate into the bench top opening.
With a screwdriver assemble the brackets (A) to
the hotplate bottom by means of the screws (B)
(See Fig. 4). Slide the hooks into position and
secure them with the screws. Trim the part of the
sealing strips that extend beyond the hotplate
base.
Gas Connection
Please review gas connection on page 15.