FAQ

9
1. Measure the distance from the floor to the where the chain connects on the back of
the appliance.
2. Position the ends of the chains on the wall at the desired height plus 1/8 ̋ (0.32
cm). The chains must be placed at 2 & 5/16” (6.0cm) from the side of the range. The
distance between the two chains is 25 & 1/4 “(64.1 cm).
3. Secure the ends of the chains to the wall with appropriate hardware.
4. Slide the range against the wall. (I don’t think we need any more info on this since
we no longer provide a bracket)
5. Check to see that the Anti-Tip chains are connected properly. Then grasp the top
rear edge of the range and carefully attempt to tilt it forward. Verify that the Anti-Tip
device is engaged.
6. Or use the anti-tip device as one chain and tighten up with fixed screw on the wall.
If the wall is not suitable for installation, then the chain shall be fixed to the cabinet
structure.
7. The two sides of the chains are fixed on the wall or cabinet structure.
Installing the Anti-tip Stability device
Installing the Anti-Tip
Stability Device