Use and Care Manual

31 32
Maintaining Your Range
Cleaning Your Range
Cleaning after Installation: Use a stainless steel cleaning product or wipe to elimi-
nate the glue residues of the blue protection film after removal.
Cleaning the Worktop: Periodically clean the burner heads, the cast iron pan
supports, and the burner caps using warm water. Remove burner food and fat
residues with a rub-ber spatula.
Cleaning Stainless Steel: For the best results use a stainless steel cleaner product with
a soft sponge or cloth with a warm soap and water solution. Never use abrasive
powders or liquids.
Cleaning the Burner Caps: Lift the burner caps from the burner heads and wash them
in a warm soap and water solution. Dry thoroughly before using them again. Before
reinstalling them on the burner head, check that the gas flow holes are not clogged
with food residues or cleaning products.
Cleaning Enamel: Enameled parts should be cleaned frequently with warm soap
and water solution applied with a soft sponge or wipe. Never use abrasive powders
or liquids! Do not leave acid or alkaline substances on the enameled parts (such
as vinegar, lemon juice, salt, tomato sauce etc.) Use a rubber spatula to remove fat
residues.
Cleaning Glass Door: Clean the glass using a non-abrasive sponge or wipe with a
warm soap and water solution. Use a rubber spatula to remove fat deposits.
During cleaning operation never move the appliance from its original
installation position. Never use abrasive cleaners! Scratches on the
stainless steel surfaces are permanent. Do NOT clean the range when hot!
WARNING
Troubleshooting
Possible Cause and/or Remedy
Range is not connected to electrical power. Check
power circuit breaker, wiring, and fuses.
Temperature control knob is rotated too far past
broil position (500°F); preheating indicator will
light intermittently.
Oven is still in self-clean mode. Door latch will
release when a safe temperature is reached.
The circuit is tripped, fuse is blown, or range is not
connected to power.
Gas supply valve is in the “OFF” position or gas
supply is interrupted.
Burner ports are clogged or the unit is not set to
the appropriate gas type. Call a technichian to
repair.
Turn the oven off at the circuit breaker and wait 5
minutes. Turn the breaker back on and the oven
will reset itself.
Check the circuit breaker or fuse box to your
house. Make sure ther is proper electrical power
to your oven.
Replace or reinsert the light bulb if loose or
defective.
Check for obstruction in the oven door. Check to
see if hinge is bent.
There may be soil or build up on the lens cover.
Wipe the lens cover with a clean, dry towel prior
to attempting to remove the lens cover.
Oven Problem
Range does not function
Broil does not work
Door does not open
Igniter does not work
Igniter sparking taut; No flame ignition
Burner ignites but flame is large,
distorted, or yellow
Oven door is locked and will not
release, even after cooling.
Oven is not heating
Oven light is not working properly
Oven light stays on
Cannot remove lens cover on light