Use and Care Guide

Sink Installation

Top Mount Installation Continued

3. Drain Installation

Insert the metal strainer into the rubber seal, and then into the draining hole.

Install the rubber gasket and the main drain body underneath the sink.

Using the screw, tighten the main drain body and the metal strainer into place.

Install the basket on top of the metal strainer.

Repeat the same procedure for the installation of the second draining hole (twin and

double bowls only).

Note: plumber putty is not required for the installation of these drains.

4. Insert Sink

Verify that the sink ﬁts perfectly. The lip of the sink should be resting on the countertop.

5. Insert Clips

Insert clips into the rails.

6. Fix the Clips

Fix the clips into place.

7. Seal with Silicone-based Sealant.

Seal with silicone-based sealant all around the sink.

8. Pipe Installation

Install the faucet following the manufacturer’s instructrions.

Excess sealant must be removed prompltly with a suitable clean-up

solvent recommended for use on both the counter and sink to ensure

damage does not occur.