Use and Care Guide

26
Preparation
Decide the location of the venting pipe from the hood to the outside.
Check hood for clearance.
A straight, short vent run will allow the hood to perform more efficiently.
Try to avoid as many transitions, elbows, and long runs as possible. This may reduce
the performance of the hood.
For installing under the cabinet with recessed bottom, attach 4-inch wide wood filler
strips (not provided) on each side.
Puncture the knockout holes (for mounting under the cabinet) on the hood.
Step 1
Measure distance between stove
top and the bottom of the range
hood. A distance of 30” to 36” is
recommended.
Step 2
Attach mounting brackets to the
back of the hood.
Step 3
Mark the leveling point of the
hood. Position two mounting
screws on the wall, leaving ¹/₈”
space away from the wall. Make
sure that you are mounting the
hood to a secure backing to hold
the weight of the hood.
Step 4
Tighten ducting (provided) with
the hose clamp provided. Use
silver or duct tape wherever
needed.
Under cabinet Installation