Use and Care Guide

If you need to convert your under cabinet range hood to

rear ducting, use the following instructions. Please note that

converting the undercab to rear ducting is a modiﬁcation

of the standard hood and part of the installation process.

It is recommended that the hood is inspected before this

procedure. Only certain undercab models allow for rear

ducting. Contact us at 1-614-777-5004 for more information

on compatible models.

Step 1

First remove the screws from the stainless steel panel. The

small screws attach the panel to the range hood while the

larger screws attach the panel to the motor.

Step 2

Remove the panel from the hood. The motor is attached to the

panel. Do not disconnect the motor from the panel. The image

to the right shows an example of the motor orientation.

Step 3

Remove the blower/motor from the range hood. Be careful

not to pull and disconnect the attached wiring.

Step 4

Rotate the blower/motor so that the opening is facing out the

rear of the range hood.

Step 5

Replace the panel so that the opening aligns with the opening

of the blower/motor.

Step 6

Attach the panel to the range hood then attach the blower/

motor to the panel using the larger screws.

Under-Cab Rear Ducting Conversion