Use and Care Guide

24
Step 6
Slide chimney pieces over the angle iron on the
hood. Pull the electrical plug to the top of the
chimney sections. Figure 4
Step 7
Lift the hood to attach the angle iron
to the ceiling bracket. Use screws provided to
attach.
Step 8
Make your electrical and ducting connections. Use rigid duct wherever possible.
Try and minimize the use of elbows. More elbows and longer runs create higher
static pressure. The hood comes with a grounded three prong plug that can either be
directly wired or plugged into a 20 amp circuit. The cord is 68.5” long.
Step 9
Slide top chimney piece up over the mounting
bracket on the ceiling and secure it in place
with the provided screws. Figure 5
Step 10
Install stainless steel baffle filters. Before
installing baffle filters, make sure that you
insert the grease cup under the motor blower.
Figure 4
Figure 5
With any of our wooden or copper range hoods, you can custom
cut the chimney to the desired height and the crown molding will
hide any jagged cuts and offer a seamless transition to the ceiling.
The range hood is very heavy. Use the buddy system to keep the
chimney in place while screwing in the hood into the brackets.
WARNING
WARNING
Designer Island Hood Installation