Use and Care Guide

3231
TROUBLESHOOTING
RANGE PROBLEM POSSIBLE CAUSE AND/OR REMEDY
Range does not function Range is not connected to electrical power. Check
power circuit breaker, wiring, and fuses. If all
electrical components are properly installed, call
customer support.
Broil does not work Temperature control knob is rotated too far past
broil position (500°F); preheating indicator will
light intermittently.
Burner does not ignite Gas supply valve is in the “OFF” position or gas
supply is interrupted.
Igniter sparking taut; no flame
ignition
Burner ports are clogged or the unit is not set to the
appropriate gas type. Call customer support.
Burner ignites but flame is large,
distorted, or yellow
The air quality of the room is affecting the flame
color. Ensure that there are no candles, cleaning
products, etc. in the room.
Oven is not heating Check the circuit breaker or fuse box to your
house. Make sure there is proper electrical power
to your oven.
Oven light is not working properly Replace or reinsert the light bulb if loose or
defective.
Oven light stays on Check for obstruction in the oven door. Check to
see if hinge is bent.
Cannot remove lens cover on light There may be soil or build up on the lens cover.
Wipe the lens cover with a clean, dry towel prior
to attempting to remove the lens cover.
Low flames and longer cooking
times
The propane conversion procedure may not have
been performed properly. Check that all orifices
are correctly placed. If not, contact your installer.
Brass burners changed color Brass burners naturally oxidize over time and form
a patina that is a beautiful deep brass hue. This
process ensures our brass burners are corrosion
resistant and is not cause for a return.
Troubleshooting
Door does not lock during cleaning.
Use caution.
WARNING
• Cleaning Porcelain: Porcelain parts should be cleaned frequently with warm
soap and water solution applied with a soft sponge or wipe. Never use abrasive
powders or liquids! Do not leave acid or alkaline substances on the porcelain
parts (such as vinegar, lemon juice, salt, tomato sauce etc.) Use a rubber spatula
to remove fat residues.
• Cleaning Glass Door: Clean the glass using a non-abrasive sponge or wipe with
a warm soap and water solution. Use a rubber spatula to remove fat deposits.
Install the pins into slots on each hinge (pins not included.)
CHANGING DOORS
1. Carefully lift the door out of the range.
2. Uninstall the kick plate by unscrewing the four screws in the corners of the
kick plate. There are two at the top and two at the bottom on each side. Have
another helper tilt the range to unscrew the bottom screws.
3. Slide out the kick plate.
4. Slide in the new kick plate.
5. Screw in the four screws to secure the kick plate.
6. Hook the new range door onto the range. Make sure that the door is secure.
7. Remove the pins.
Changing
doors video
Changing Doors
MAINTENANCE AND CLEANING
Troubleshooting
Changing Doors
SCAN ME