Installation Guide

33 34
Troubleshooting
Possible Cause and/or Remedy
This is a fault alarm indicating the failure of the
cooling fan(s). Try resetting it by turning both
selectors to the OFF position. If the error is
not repaired, call a qualified technician. If not
repaired, this error indicator will appear again
within 10 seconds once the oven is activated with
any function for which cooling fans are required to
operate, preventing the use of the oven.
This is a fault alarm indicating failure of the oven
sensor temperature probe; in this case, cooling
fans will start automatically. To reset, switch both
selectors to the OFF position. To stop buzzer and
light indicator, disconnect the appliance from
the main electrical supply and call a qualified
technician for repair.
Electrical power failure happening during
cleaning cycle operation; cleaning cycle
interrupted; cooling fans remain both activated.
The error will be reset by putting 2 selectors in the
OFF position. Repeat cleaning cycle after 3-4
hours if needed.
Interruption/stop of an incomplete cleaning
cycle. Accidental displace-ment of one of the 2
oven selectors from the CLEAN position during
cleaning cycle operations. Put both selectors in the
OFF position, wait until the door latch unlocks the
door . When oven temperature is dropped below
500°F / 260°C, reselect a desired oven function.
Wrong temperature knob selection in oven
functions broiler or convection broiler. Select OFF
position and then the desired temperature under
Tmax position on temperature selector.
Oven Problem
Pre-heating idicator lights up
intermittently with sound alarm on
Heating indicator light turned on
intermittently with sound alarm on
Clean indicator light on intermittently
with sound alarm on
Clean indicator light turned on
intermittently with sound alarm off
Preheating indicator light on
intermittently with sound alarm on
Thank you for joining
the ZLINE family