Installation Sheet

3736
Replacing the Circuit Board
Changing the Button Panel
CHANGING PARTS
Installation
Tutorial
Video
ground
ground
HOW TO CHANGE OUT THE BUTTON PANEL
1. Remove baffle/aluminum filters.
2. Locate back of button panel.
3. Remove screws from each side of the button panel.
4. Disconnect button panel from cord connecting to circuit board.
NOTE: Never work on or clean the range hood while power is ON. Always unplug
the unit or switch the electrical breaker to the off position.
CHANGING PARTS
HOW TO REPLACE THE CIRCUIT BOARD
1. Turn the power off at the breaker and unplug the Range Hood.
2. Remove all screws from the top of the circuit board cover.
3. Take a picture of the wiring layout (this will help you put the circuit board back
together properly).
4. Remove the wiring connected to the circuit board.
5. Remove the screws from the circuit board.
6. Replace the wiring and screws to reassemble the new circuit board per the
diagram below.
NOTE: Never work on or clean the range hood while power is ON. Always unplug
the unit or switch the electrical breaker to the off position.
Installation Tutorial Video
ground
ground
Scan Me
Scan Me