Installation Sheet

ManualsBrandsZLINE ManualsAppliancesProfessional 60" Externally Vented Range Hood - Stainless steel

1918

Island Hood Installation

Please unpack your range hood when it is delivered and inspect to ensure all parts are

included.

PARTS SUPPLIED

NOTE: Island range hoods with single motors will come with a square to 6˝ round

transition piece and will include a back draft damper. The ducting with these range hoods

is 6˝. Dual motor wall hoods will come with a square to 8˝ round transition piece without

a back draft damper. The ducting with these range hoods is 8˝ in diameter.

Use rigid ducting wherever possible. Try and minimize the use of elbows. It is

recommended to establish 15-20” of vertical airﬂow from the top of the hood before

executing a 90° turn or elbow. More elbows and longer runs create higher static

pressure. No more than two to three elbows are recommended. Use 40 feet of ductwork

max. The hood comes with a grounded three prong plug that can be plugged into a 15

amp circuit.

ISLAND HOOD INSTALLATION

1. Main Hood with All Lights and

Button Banks Pre-Installed

2. Chimney

3. Transition Piece (for 6” or 8”)

4. Bafﬂe Filters

5. Flexible Duct (for 6” or 8”)

6. Packet of Screws and Anchors

7. Top Mounting Bracket

8. Grease Cup

The recommended height to install your hood is 30˝ minimum and 36˝ maximum

above the cooktop. For Outdoor (304 Series) hood installation, the unit must be

installed at a minimum of 36˝ and a maximum of 42” above the grill.

1. Locate the center above the stove where the hood is to be installed. Ensure that

the bracket will be secured to solid wood backing. Attach mounting bracket to

the ceiling.

2. Attach the transition piece and ducting to top of the hood. Figure 1 and 2

3. Attach the four long angle iron pieces to the hood’s motor housing. Figure 3

4. Determine desired height and attach the four short angle iron pieces to the long

angle iron pieces that are attached to the hood. Figure 3

5. Install the duct work in the center of the ceiling bracket.

ISLAND HOOD INSTALLATION

Figure 1

Figure 2

Figure 3

Screw: F

Screw: H/I

Screw: H

Screw: G

Screw: A/C/D

1. Screw

2. Screw

Screw