Installation Guide and User's Manual

11
Step four: Attach the duct to the top
of the back draft damper. Place the
chimney sections over the lower
bracket section and on top of the
main unit. Pull the plug to the top of
the chimney sections. Attach lower
bracket to upper bracket at desired
height using screws provided. fig.4
fig.4
fig.5
fig.6
Step 5: Make your electrical and
ducting connections. Use 6” rigid
duct wherever possible. Try and
minimize the use of elbows. More
elbows and longer runs create higher
static pressure. The hood comes
with a grounded three prong plug
that can either be direct wired or
plugged into a 20 amp. circuit. Next
slide the inner portion of the chimney
up around the upper bracket and
secure using the screws provided.
fig.5-6
6
4