Owners Guide

32 33
Replace or Change Charcoal Filters:
It is recommended to direct vent the hood whenever possible.
If your situation does not allow for a direct vent install, carbon filters are available to
recirculate the air through your hood.
1. Remove the stainless steel or aluminum filters from the bottom of the hood.
2. Locate the existing raised support screws on each side of the internal motor(s).
3. For each motor side, position the filter over its support screw and rotate to lock into
place.
Note: Replacement is recommended after 130 hours of cooking or 6 months of
operation. Replace more often if your cooking habits generate more grease.
Note: Never work on or clean the range hood while power is ON. Always unplug
the unit or swtich the electrical breaker to the off position.
How to Change Parts
Change/Replace Capacitor:
1. Remove screws from the circuit board cover.
2. Remove screws from compacitor.
3. Remove both wired connections from the capacitor.
4. Connect new capacitor with wire connectors.
5. Replace screws in cover.
6. Repeat operation if dual motor.
Note: Some units have more than one motor. If you have a unit with dual motors,
there will be two capacitors.
Note: Never work on or clean the range hood while power is ON. Always unplug
the unit or swtich the electrical breaker to the off position.
Installation
Tutorial
Video
Installation Tutorial Video
How to Change Parts
Filter Support Screws