Owners Manual

2423
Alpine Under Cabinet Electrical Connection
NOTICE: Considering excessive weight, two or more people are required to install or
move this appliance. Failure to do so can cause physical injuries.
GROUNDING INSTRUCTIONS
15amp, 120V, 60Hz
This appliance must be grounded. The range hood is equipped with a cord having a
grounding wire with a grounding plug. The plug must be plugged into an outlet that is
properly installed and grounded.
WARNING: Improper grounding can result in a risk of electric shock.
Consult a qualified electrician if the grounding instructions are not completely
understood or if doubt exists as to whether the appliance is properly grounded.
Do not use an extension cord. If the power supply is too short, have a qualified
electrician install an outlet near the appliance.
PREPARE THE HOOD
Unpack hood and check contents. You should receive:
1. Hood
2. Installation Instructions
3. Aluminum Flex Duct
4. Parts Bag containing:
Mounting bracket
QTY: 2
Hose clamp
QTY: 1
Explode Screws
QTY: 2
M4*12
QTY: 4
Mounting bracket
QTY: 2
Hose clamp
QTY: 1
Explode Screws
QTY: 2
M4*12
QTY: 4
Mounting bracket
QTY: 2
Hose clamp
QTY: 1
Explode Screws
QTY: 2
M4*12
QTY: 4
Mounting bracket
QTY: 2
Hose clamp
QTY: 1
Explode Screws
QTY: 2
M4*12
QTY: 4
Mounting bracket
QTY: 2
Hose clamp
QTY: 1
Explode Screws
QTY: 2
M4*12
QTY: 4
WARNING
WARNING
Hose clamp
QTY: 1
Mounting bracket
QTY: 2
Aluminum Flex Duct
QTY: 1
Explode screws
QTY: 2
M4*12
QTY: 4
BEFORE INSTALLATION
ALPINE UNDER CABINET MODELS
Alpine Under Cabinet Venting Specifications
Roof cap
Duct (for vertical discharge)
Duct (for horizontal discharge)
Wall cap
House wiring
Cabinet
Hood
24”-30” (Electric hob)
30”-32” (Gas hob)
Ply wood or
solid flatform
Wood block
approx 2.” thick
30”/36”/42”
28.4”/34.7”/41”
10”
2”
22”
12”
8”
NOTE: Carefully remove the plastic protective film from exterior of the surfaces of
the hood prior to final installation.
CAUTION: To reduce risk of fire and electric shock, install this range
hood only with integral blowers by qualified person or agency.
WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR
INJURY, OBSERVE THE FOLLOWING:
1. Installation work and electrical wiring must be done by qualified person(s)
in accordance with all applicable code and standards, including fire-rated
construction.
2. Sufficient air is needed for proper combustion and exhausting of gases through
the flue (chimney) of fuel burning equipment to prevent back drafting. Follow
the heating equipment manufacturer’s guideline and safety standards, such as
those published by the National Fire Protection Association (NFPA), and the
local code authorities.
3. When cutting or drilling into the wall or ceiling, do not damage electrical wiring
and/or other hidden utilities.
4. Ducted fans must always be vented to the outdoors.
CAUTION
WARNING
BEFORE INSTALLATION
ALPINE UNDER CABINET MODELS
Alpine Under Cabinet Tools
Alpine Under Cabinet Preparation