Trim Kit User Manual and Install Guide

INSTALLATION

5. Push the microwave into the slot in the rear bracket by extending the support beam

(Figure 1).

6. Use screw #3 to ﬁx the front bracket and support beam (Figure 2).

7. Insert the trim kit into the corresponding buckle seat.

INSTALLATION

Installation

①

②

①

Push the microwave which had install bracket into the slot in the rear bracket by extending the

support beam( picture 1)将预装好的微波炉顺延着支撑横梁推到后支架卡槽内为止（如图一）

② Use 3# screw to fix the front bracket and support beam( picture 2)再用 3#螺丝安装前支架与支撑横

梁对应孔位（如图二）

complete

Picture 1

Picture 2

Figure 1

Figure 2

① Insert the trim kit into the corresponding buckle seat 将

预装好外观框卡进对应卡扣座里

Finish

Installation