Installation Guide and Users Manual

25
Inst allat ion Instructions
Attach the microwave oven to the top cabinet.
Cabi net Front
Cabi net Bot t om Shelf
Filler Block
Microwave Oven Top
Equi val ent to Depth
of Cabi net Recess
3
MOUNT THE M ICROWAVE OVEN
FOR EASIER INSTALLATION AND PERSONAL
SAFETY, WE RECOMMEND TH AT T WO PEO PLE
INSTALL THIS MICROWAVE OVEN.
NO T E: I f your cabin et is metal, use th e n yl on
gr ommet ar oun d th e power cor d hol e to pr event
cutting of the cord.
NO T E: We recommend using filler blocks if the
cabinet front hangs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are not used,
case damage may occur f rom overtightening
scr ews.
Insert a self-aligning screw through top center
cabi n et hole. Tempor ar il y secur e t he oven by
turning the screw at least two f ull turns after the
thr eads have engaged. (It will be completely
ti ghtened l ater.) Be sur e t o keep power cor d
tight. Be careful not to pinch the cord, especially
when mounting f lush to bottom of cabinet.
Sel f-Ali gni ng Screw
4
2
Rotate front of oven
up agai nst cabi net
bottom.
NO T E: When mounting the
mi cr owave oven, thr ead
power cord through hole in
bottom of top cabinet. Keep
it tight throughout Steps
1–3. Do not pinch cord or
lift oven by pulling cord.
Lift microwave, tilt
it forward, and hook
slots at back bottom
edge onto four lower
tabs of mounting
pl ate.
1
C3.
C4.
CHECK BLOWER PLATE
Bl ower Pl at e
• Place the microwave in its upright position, with the
top of the unit facing up.
• Check to see th at th e blower pl ate i s cor r ect l y
installed on the unit.
USE TOP CABINET TEM PLATE
FOR PREPARATION OF TOP
CABINET
C2.
•
Read the instructions on the TOP CABINET
TEMPLATE.
• Tape i t un der neath th e top cabinet.
• Drill the holes, following the instructions on the
TOP CABINET TEMPLATE.
CAUTION: Wear safety goggles when drilling holes
in the cabinet bottom.
You need to drill holes for the top support screws and
a hole large enough for the power cord to fit through.
Adjust top template accor dingly if the m i cr o wave
is being spaced out from the wall due to cabinet depth
(including cabinet doors) of more th n 13"""''.
NO T E:
a
IMPORTANT: Do not grip or use the handle
or heat shield during installation. Do not
r emove t he car dboard spacer s between t he
heat shield and door.
EN-21
INSTALLATION