Manualshelf

Owner's Guide

ManualsBrandsZLINE ManualsCooking Appliances36 Inch Freestanding Dual Fuel Range with 6 Sealed Italian Burners, 4.6 cu. ft. Convection Oven Capacity, Continuous Grates, Three-Layer Glass Oven Window, Stay-Put Hinges, Porcelain Cooktop, UL Listed, and ETL Certified: Blue Matte
12345678910
7 8
Installing the Legs
The ranges must be used with the legs properly installed. Four height-adjustable legs
are shipped with the range, in a foam container above the range.
1. Before installing the legs, position the appliance near its final location as the legs
are not suitable for moving the appliance over long distances.
2. After unpacking the range, raise it enough to insert the legs in the appropriate
receptacles situated on the lower part of the appliance. Lower the range gently to
keep any undue strain from legs and mounting hardware.
3. Adjust leg height to the desired level by twisting the inside portion of the leg
as-sembly until the proper height is reached. Check with a level that the cooktop is
perfectly level.
Installing the Legs
Installing the Anti-Tip Stability Device
The Anti-tip bracket shipped with the range must be properly
secured to the rear wall as shown in the picture on the following page.
The height of the bracket from the floor must be determined after the range legs
have been adjusted to the desired height and after the range has been leveled.
Installing the Anti-tip Stability device
A child or adult can tip the range and be killed; Re-engage the
anti-tip device if the range is moved. Failure to do so can result in
death or serious injury.
WARNING
Range Top/Drop-in Installation
Attaching the hotplate
To prevent liquids from accidentally leaking into
the underlying storage space, the appliance is
equipped with a special gasket. To apply this
gasket, carefully follow the instructions in Fig.
3. Lay out the protective sealing strips along
the edges of the opening in the bench top and
carefully overlap the strip end. (See Fig. 3).
insert the hotplate into the bench top opening.
With a screwdriver assemble the brackets (A) to
the hotplate bottom by means of the screws (B)
(See Fig. 4). Slide the hooks into position and
secure them with the screws. Trim the part of the
sealing strips that extend beyond the hotplate
base.
Gas Connection
Please review gas connection on page 15.