Installation Guide and Users Manual

25 26
Oven Cooking
Be sure to set all worktop/oven/broiler burner controls to the OFF position after each
use of the appliance.
Maximum temperature setting/recommended control knob position for burner
ignition.
Minimum Temperature Setting
Appliance with Worktop Gas Valves
Alternative Type
OFF
OFF
OFF
Using the Oven
Surface Burner Operation - Electric Ignition
To activate the electric ignition, simply turn the control knob counter-clockwise to
maximum power (*position*), then press the knob in to start the flow of gas and
the ignition spark. The spark will be re-leased at the metal tip of the white ceramic
pin located on the side of the burner. Once the flame is on, release the control knob
gently. If the flame turns off, simply repeat the above procedure.
Manual Ignition
Manual ignition is always possible even when the power is cut off, or in the event of
a power failure. Turn the control knob counter-clockwise to the MAXIMUM position;
light the flame with a kitchen lighter or with a match.
Using the Burners Correctly
1. Always check that the burner caps are properly installed before operation:
2. Verify that the flame of the worktop burners is completely blue and with a regular
aspect as shown below:
3. Always adjust the burner flame so it does not extend beyond the edge of the pan.
DO NOT ignite the burners if the black burner cap is not installed or
not centered, the flame will be irregular.
Keep children at a safe distance from the appliance during
operation. DO NOT allow children to operate the appliance!
WARNING
WARNING
A
B
A
B
Correct
Incorrect
Correct Incorrect
A
B
A
B
A
B
Correct
Incorrect
Correct Incorrect
A
B
A
B
A
B
Correct
Incorrect
Correct Incorrect
A
B
Note: When igniting a burner, all burners will spark, but only
the burner’s knob you are using will ignite the flame.