Installation Guide
Step 1: PRESSURE REGULATOR
e pressure regulator supplied with the appliance
is a convertible type pressure regulator for use with
Natural Gas at a nominal outlet pressure of 4˝ w.c. or
LP gas at a nominal outlet pressure of 11” w.c. and it
is pre-arranged from the factory to operate with one
of these gas/pressure as indicated in the labels axed
on the appliance, package and instruction booklet.
To convert the regular for use with other liquid propane
LP gas:
1. Unscrew by hand the upper cap of the regulator,
remove the white plastic attachment from the
e gas conversion procedure for this range
includes:
1. Pressure Regulator
2. Surface Burners
3. Adjustment of Minimum Setting
e conversion is not completed if all steps are not
completed.
Before performing the gas conversion, locate the
package containing the replacement nozzle has a
number indicating its ow diameter printed on the
body. Consult the table on page 20 for matching noz-
zles to burners.
Save the nozzles removed om the range for future use.
Gas Conversion Procedure
cap, reverse its direction and screw it again rm-
ly against the cap. e white plastic attachment
has arrows indicating the position for natural gas
(NAT) and LP gas (LP).
2. Screw by hand the metal cap in the original posi-
tion on the regulator.
Step 2: SURFACE BURNERS
T
o replace the nozzles of the surface burners, li up
the burners and unscrew the nozzles shipped with
the range using a 7 mm (socket wrench).
Replace nozzles using the conversion set
supplied with the range. Each nozzle has a number
indicating its flow diameter printed on the body.
Consult the table on page 19 for matching nozzles
to burners.
Step 3: MINIMUM FLAME ADJUSTMENT
WARNING!
ese adjustments should be made only for use of the
appliance with natural gas. For use with liquid pro-
pane gas, the choke screws must be fully turned in a
clockwise direction.
9