Installation Guide

Electrical Grounding
This appliance is equipped with a three
-prong plug
for your
protection
against shock hazard and
should be plugged directly into
a properly grounded
receptacle, do not cut or remove the prong from this
plug.
ELECTRICAL SHOCK HAZARD
Disconnect electrical power at the circuit breaker
box or fuse box before installing the appliance.
Provide appropriate ground for the appliance. Use
copper conductors only.
Failur
e to follow t
hese instructions
could result in serious injury or death.
Electrical Connection
The appliance operate at a main voltage of 120V a.c.,
frequency 60Hz. Electric power absorption is about
1W for 5 gas burner version or 2W for 6 g as burners
version.
WARNING!
CAUTION!
Label all wires prior to disconnecting when servicing
controls. Wiring errors can cause improper and danger-
ous operation. Verify proper operation aer servicing.
Check your local code for which of the options be-
low should be used in grounding the receptacle pow-
er supply connections.
DO NOT USE EXTENSION CORDS WITH
THIS APPL
IANCE AS IT MAY RESULT IN
FIRE, ELECTRIC SHOCK OR OTHER TYPES
OF PERSONAL INJURY.
e appliance is equipped at the factory with an
electric supply cord set 4 wires type with ring ter-
minals(L1, L2, N, Ground) suitable for range use
U:/CSA listed type SRDT/DRT 2x6AWG (L1,
L2,)+2x8AWG(N, G) rated 300V, 40 or 50A with
fused plug type NEMA 14-50P, cable length 1.5m;
in case the supply cord set must be replaced, it shall
be replaced with an identical set having the same
technical specs and following carefully the instruc-
tions and diagrams above.
11
Fig. 3
Wiring diagram description
1. Cable terminal 2. Ignition switch 3. Spark generator
4. Ignition spark L. Black N. White T. Green (earth)