Installation Guide
WARNING!
Pressure Test Point Stopper Valve
To avoid gas leaks, the pressure test-point stopper
valve and gasket supplied with the range must be
installed on the gas tting at the back of the range
according to the diagram below.
Pressure Regulator
Since service pressure may uctuate with local de-
mand, every gas cooking appliance must be equipped
with a pressure regulator on the incoming service
line for safe and ecient operation.
Pressure Regulator
e pressure regulator shipped with the appliance
has two female threads 34”NPT. e regulator shall
be installed properly in order to the accessible when
the appliance is installed in its nal position.
Manifold pressure should be checked with a manom-
eter and comply with the values indicated below.
• Natural Gas->430”W.c.P
• LP/Propane-> 10.0” W.c.P
Incoming line pressure upstream from the regulator
must be 1˝ W.c.P. higher than the manifold pressure
in order to check the regulator.
e regulator used on this range can withstand a
maximum input pressure of ½ PSI (13.8˝ W.c or
3.5kPa) If the line pressure exceeds that amount, a
step down regulator is required.
e appliance, its individual shut-o valve, and the
pressure regulator must be disconnected from the gas
line during nay pressure testing of that system at pres-
sures in excess of 1/2PSI (13.8˝ W.c or3.5kPa).
Appliance Servicing
Before carrying out any service disconnect, the appli-
ance from gas appliance from nal to install have ac-
cess to the appliance for proper servicing intervention.
GAS CONVERSION
Before carrying out this operation,
disconnect the appliance from
gas and electricity.
Gas conversion shall be conducted
by a factory-trained professional.
Call customer service hot-line to
identify a factory-trained professional
near your home.
13