Installation Guide

1. Light one burner at a time and set it to the MINIMUM position (small ame).
2. Remove the knob.
3. e range is equipped with a safety valve. Using a small-size slotted screwdriver, locate the
choke screw to the right or le until the burner ame is adjusted to desired minimum.
4. Make sure that the ame does not go out when switching quickly from the MAXIMUM
TO THE MINIMUM position.
Is the electricity properly grounded?
Is the gas service line connected following the directions of
the manufacturer?
Have all the proper valves, stoppers and gasket been
installed between the range and the service line?
Has the gas connection been checked for leaks?
Has the range been setup for the type of gas available in the
household? (LP6/PROPANE OR NATURAL GAS)
Does the flame appear sharp blue, with no yellow tipping?
Has the minimum setting for all burners been adjusted?
1
2
3
4
5
6
Installation Checklist
Surface Burners
14