Installation Guide
Surface Burner Operation / Electric Ignition
To activate the electric ignition, simply turn the con-
trol knob counter-clockwise to maximum power
(*position*), then press the knob in to start the ow
of gas and the ignition spark. e spark will be re-
leased at the metal tip of the white ceramic pin lo-
cated on the side of the burner. Once the ame is on,
release the control knob gently. If the ame turns o,
simply repeat the above procedure.
Do not ignite the burners if the black burner cap is not
installed or not centered, the ame will be irregular.
Manual Ignition
Manual ignition is always possible even when the
power is cut o, or in the event of power failure.
Turn the control knob counter-clockwise to the
MAXIMUM position; light the ame with a kitch-
en lighter or with a match.
Tips For Using Burners Correctly
Keep Children at a Safe Distance From
the Appliance During Operation.
Do Not Allow Children to Operate
the Appliance!
Important User Information!
WARNING!
Important!
Attention!
Reset all, worktop/oven/broiler burner, controls
in the OFF position aer use of the appliance.
1. Always check that the burner caps are properly
installed before operation.
2. Verify that the ame of the worktop burners
be completely blue and with regular aspect
as shown below.
3. Always adjust the burner ame so it does not
extend beyond the edge of the pan.
18