Installation Guide

Attaching the hotplate

Installation Procedure

Fig. 3

Fig. 4

To prevent liquids from accidentally leaking into the

underlying storage space, the appliance is equipped with

a special gasket. To apply this gasket, carefully follow the

instructions in Fig. 3. Lay out the protective sealing strips

along the edges of the opening in the bench top and

carefully overlap the strip end. (See Fig. 3). insert the

hotplate into the bench top opening. With a screwdriver

assemble the brackets (A) to the hotplate bottom by

means of the screws (B)(See Fig. 4). Slide the hooks into

position and secure them with the screws.

Trim the part

of the sealing strips that extend beyond the hotplate base.

Fig. 5

Fig. 6

Gas connection

Before connecting the appliance to the gas supply, first

remove the plastic plug that is press-fitted into the gas

inlet union; to remove, just pull it out.

1. Check the ‘gas type’ sticker attached to the

hotplate. Details of the injector sizes used are

recorded on the data plate located on the base of

the appliance.

2. This appliance shall be installed in accordance with

installation requirements of the local gas authority

of the appropriate installation code.

3. Before installing the hotplate consider the location

of the gas supply and routing the gas line.(Refer

fig.6)

For LPG models the gas supply is connected to the

regulator male thread. For NG models it is supplied

loose. It is essential that the elbow on the appliance be

held firmly with a spanner when connecting the supply.

Do NOT over tighten.

The regulated pressure For LPG is 10" w.c. (See Fig. 5).

The regulated pressure for is 4" w.c.